Specifications Category Specification Model Series Lexium 28 EVS10N (Common variants: EVS10N16PC, EVS10N20PC, EVS10N28PC). The numeric suffix (16, 20, 28) indicates the continuous output current rating in Amps. Main Power Supply Voltage: 200-480 VAC, ±10% Phase: Three-phase Frequency: 50/60 Hz Note: This is a key differentiator from the lower-power EVS08N (100-240V). Control Power Supply 24 VDC (±15%) – for logic circuits and safety functions (STO). Output to Motor Type: 3-phase sinusoidal PWM Rated Continuous Current: 16 A, 20 A, or 28 A RMS (depending on model) Peak Current: Typically 2-3x continuous current for short durations. Max. Output Frequency: 500 Hz Compatible Motors: Primarily BCH2 Series (medium frame), and other standard 3-phase PMSMs. Control Modes • Torque Control • Speed Control • Profile Position Control (with internal interpolator) • Homing Mode • Master/Slave following (electronic gearing, camming) Feedback System Supports high-resolution incremental encoders (SinCos 1 Vpp) and absolute encoders (EnDat 2.2, Hiperface). Communication Interfaces • Fieldbus: Integrated CANopen (DS402 profile) as standard. • I/O: Digital inputs (6), digital outputs (3), analog input (±10V), analog output. • Programming Port: Mini-USB for configuration via SoMove software. Key Features • Integrated Safety: Safe Torque Off (STO) per EN 61800-5-2, SIL 3. • Advanced Tuning: Automatic and manual tuning functions for optimal system response. • Application Functions: Electronic gearing, cam profiling, flying saw, brake control, inertia estimation. • Comprehensive Protections: Overcurrent, overvoltage, short circuit, motor overload/overheating, ground fault. Environmental Ratings Operating Temperature: 0°C to +55°C (with derating above 45°C) Storage Temperature: -25°C to +85°C Humidity: < 95% non-condensing Pollution Degree: 2 Overvoltage Category: III Installation Altitude: Up to 1000m without derating. Mounting & Cooling IP20 protection degree. Requires panel mounting on a certified, properly sized heat sink (thermally conductive backplate) for heat dissipation. Forced air cooling may be required at high loads. Certifications CE, UL, cULus. Complies with IEC/EN 61800-5-1, IEC/EN 61800-3.