Parameter Category Specification General Information Product Series Eaton MVX9000 (M-Max Series) Article Number / Model MMX34AA4D3F0-0 Type Industrial AC Drive (VFD) Enclosure Rating IP20 / UL Type 1 (Open Chassis). Must be installed in a proper enclosure. Standards Compliance cULus, CE, RoHS. Compliant with IEC/EN 61800-5-1. Power Characteristics Rated Output Power 7.5 kW (Decoded from "34" in model number, where "34" typically corresponds to the 7.5kW/10HP frame). Output Horsepower (HP) 10 HP Input Supply (Line) 3-Phase, 200-240V AC (+10%/-15%), 50/60 Hz Output to Motor 3-Phase, 0-240V AC, 0-400 Hz Rated Output Current 24 A (This is the continuous current rating for the 7.5kW model). Overload Capacity 150% of rated current for 60 seconds. Control & Performance Control Methods Enhanced V/f Control, Sensorless Vector Control (SVC), Closed Loop Vector Control (with optional encoder feedback card). Frequency Reference Sources • Analog Input (0-10V, 0/4-20mA) • Digital Preset Speeds • Modbus Communication • Keypad Command Sources Keypad, Digital Inputs, Serial Communication. Standard I/O • Digital Inputs: 4 programmable (sink/source) • Digital Output: 1 programmable (Open Collector) • Relay Output: 1 programmable (Changeover, 250VAC/30VDC 2A) • Analog Input: 1 (0-10V or 0/4-20mA selectable) • Analog Output: 1 (0-10V configurable) Communication Ports • RS-485 (Modbus RTU) - Standard. • Slot for Optional Communication Cards: Profibus-DP, DeviceNet, Ethernet/IP, Modbus TCP/IP, etc. Switching Frequency Adjustable (typically 2 kHz to 16 kHz). Key Built-in Features • Advanced PID Controller • DC Injection Braking • Dynamic Braking Transistor (for external brake resistor) • Auto-Tuning (Static & Rotary) • Power Loss Ride-Through • Flying Start • Skip Frequencies • Multi-Motor Control (presets) Motor & Protection Suitable Motor Three-Phase Asynchronous Induction Motor, 7.5kW / 10HP @ 230V. Protection Functions Overcurrent, Short Circuit, Ground Fault, Overvoltage, Undervoltage, Motor Overload (Electronic Thermal), Drive Overtemperature, Phase Loss, Stall Prevention, Heat Sink Overtemperature. Physical & Environmental Mounting Panel Mounting. Dimensions (W x H x D) Approx. 150 x 280 x 190 mm (Dimensions increase significantly with power rating. This is an estimate; exact size must be verified). Ambient Temperature 0°C to +50°C (40°C for full rated current; derating required above 40°C). Note: The operating temperature minimum for this frame may be higher than smaller frames. Storage Temperature -40°C to +70°C. Relative Humidity 5% to 95% RH, non-condensing. Altitude < 1000m for full rating.