Parameters Category Parameter Specification for CA4-10 General Product Type Multifunction Timer Relay (Analog Setting) Series CA4 Series Primary Function (Typical) On-Delay (TON) Power Supply Supply Voltage (Uₛ) 24-240 V AC / 24-240 V DC (Universal, auto-sensing) Frequency 50/60 Hz (for AC supply) Power Consumption Approx. 2.5 VA / 1.5 W (typical) Timing Characteristics Setting Method Potentiometer (screwdriver adjustable) Time Range Typically 0.1 sec - 30 min or 0.5 sec - 10 hours (varies by model; verify via marking) Repeat Accuracy ≤ ±1% of set value (typical) Reset Time ≤ 50 ms (typical) Input / Trigger Start Signal Voltage applied across terminals A1-A2 (power supply also acts as trigger in basic mode). Output Output Type Electromechanical Relay Contact Configuration SPDT (1 Changeover) or DPDT (2 Changeover) (1 NO + 1 NC) Contact Rating (Resistive) 8 A at 250 V AC 5 A at 30 V DC Electrical Life ≥ 100,000 cycles (at rated load) Mechanical Life ≥ 10 million cycles Indicators LEDs Green: Power On Red/Orange: Output Energized Terminals Terminal Type Screw clamp terminals Wire Size 0.5 - 2.5 mm² (AWG 20-14) Torque 0.5 - 0.6 Nm Standards & Approvals Compliance Standards IEC/EN 61812-1, UL 508, CSA C22.2 Certifications CE, cULus, CCC Environmental Operating Temperature -20°C to +55°C (with no icing) Storage Temperature -40°C to +70°C Altitude Up to 2000 m Pollution Degree PD 2 Protection Degree IP40 (front), IP20 (terminals) Physical & Mounting Mounting 35 mm symmetrical DIN rail (EN 60715) Dimensions (W×H×D) Approx. 22.5 × 76 × 90 mm (1 module wide) Weight Approx. 0.13 kg